MagPaint - instructions
- Application
MagnetPaint comes ready to use. Do not thin and never combine this product with another paint. Mix paint thoroughly with a stirring stick just prior to use. Apply a generous coat with a foam brush or foam roller. A foam brush yields the smoothest surface. If paint is to be applied on just a portion of a wall, apply masking tape border to the area, prior to painting, for a clean line. Spraying is not recommended. For best results, apply at temperature of 20°C. One liter will cover approximately over 5 square meter with one coat. Multiple coats increase magnetic receptability. Two to three coats are recommended to hold flexible "refrigerator" magnets. - Surface preparation
Proper surface preparation is essential for a long-lasting finish. Paint will not adhere to dirt, grease or water solubles such as wallpaper paste or glue sizing. Remove all loose or peeling paint. Blend edges by sanding. Wash surface with water and detergent, rinse well and allow to dry. Chalking surfaces should be thoroughly cleaned with water and a scrub brush. Remove loose material from cracks and holes, and fill with a quality spackling compound. When dry, sand smooth and wipe free of dust with a damp cloth. Smooth surfaces work best, rough concrete or cinderblock surfaces are not recommended. For good adhesion to gloss or semi gloss surfaces scuff the surface with sand-paper and use a liquid deglosser. - Drying time
Low temperatures and high humidity will inhibit drying. MagnetPaint is dry to the touch after 4 hours. A second coat of MagnetPaint or a top coat finish may be applied after 24 hrs. A top coat is not necessary, if a dark gray color is an acceptable finish. - Clean-up
All tools and equipment should be cleaned immediately after use with warm soapy water. Spills and spatters should be wiped up with a damp cloth before they dry. - Removal
If you want to be able to remove MagnetPaint at a later time, apply the paint over a strippable (removeable) wall paper. - General interest
Formulation conforms to flame spread rate of Federal Specification TT-P-26.
CAUTION: Avoid prolonged contact with skin or breathing vapors in enclosed spaces. Do not take internally. Close resealable container after each use. KEEP OUT OF REACH OF CHILDREN
Does not contain lead.
|
Magpaint Europe BV Elsterweg 3a 7076 AZ Veldhunten The Netherlands Tel: +31(0)315-386473 Company Website |
